new tm 500 in post.have experience using tm3000.from reading posts am i right in thinking that i can load first image using tm loader and ernet cable only.not the 232 cable.or is that only for updating after first image is loaded using 232 cable.thanks for any help.
tm 500 am i right?
- Thread starter dogsear
- Start date
- Messages
- 17,533
Hi mate
Use this procedure to flash your TM
Down load the image.
And flash that image to your TM like this
2. Open TM control center .
3. Start TMCC with the TechnomateCenter.exe
4. Click on the serial tab.
5. Top option set the comport to the one you have your null modem cable connected to usually com1.
6. Now click the file button and select the unrared image you downloaded earlier.
7. Now in front of your TV switch the power OFF on your TM.
8. Press in and hold the UP ^ button and then turn the power back on youll see a setup screen in front of you.
9. Press the up button for serial update then the right > button and then the ok button. This will start the image upload. Wait till it confirms the process is done.
10. Now turn off the power leave it for a min and then turn it back on.
Ferret
Use this procedure to flash your TM
Down load the image.
And flash that image to your TM like this
2. Open TM control center .
3. Start TMCC with the TechnomateCenter.exe
4. Click on the serial tab.
5. Top option set the comport to the one you have your null modem cable connected to usually com1.
6. Now click the file button and select the unrared image you downloaded earlier.
7. Now in front of your TV switch the power OFF on your TM.
8. Press in and hold the UP ^ button and then turn the power back on youll see a setup screen in front of you.
9. Press the up button for serial update then the right > button and then the ok button. This will start the image upload. Wait till it confirms the process is done.
10. Now turn off the power leave it for a min and then turn it back on.
Ferret