EBSpro+DVB Dream

B

bh62549

Registered
Messages
657
EBSpro+DVB Dream



Receiving satellite: 100.5e C + 100.5e Ku



Receiving card: TBS 6902



Port 1: ebspro (100.5e C + 100.5e KU) (versions 8.0-17.0 have tried)



Port 2: DVB dream (100.5e C + 100.5e KU)



Now if I scan 100.5e C in EBS and DVB dream watches 100.5e Ku, I cannot receive the signal. EBS scan must be switched to 100.5e Ku, which is where there is a conflict.
 
K

kebien

Registered
Messages
1,329
Being a dual tuner,you should be able.
Check LOF settings to make sure you can use both tuners independently.
 
Last edited:
B

boyet05

Registered
Messages
245
on EBS pro check tuner device and LNB setting and also on DVBDream go to diseqc setting and configure properly. If all setting are ok then it must be all good to go by restarting both app. Closing and re-opening the app will help.
 
K

kebien

Registered
Messages
1,329
bh62549 said:
How to set it in 2 software and whether to open it at the same time
Click to expand...
Programs like DVBdream let you use different plugins in different PIP folders,so you could tune couple channels at the same time.

The program should basically have 2 tuners sections for settings.
The only way a single program to tune 2 channels is through PIP.

I do not think any program could access a tuner while in use by other program,so 2 programs simultaneously is not the way to use a dual tuner card.
 
K

kebien

Registered
Messages
1,329
bh62549 said:
It seems that only two satellite Ku receivers can be used
Click to expand...
You have a solution by using L band frequencies instead of Ku or C band frequencies for each trasponder.
Using L band would just set LOF to 0,and you'd be able to tune anything.
 
You must log in or register to reply here.
Top