sat setting help

ladybreaker

Registered
Messages
5
Hello friends,
Needs help setting my vu+duo2 with opepli 7.3
I had this receiver since 2015 at that time i managed to set it up properly and was working fine up to 2 years ago that i had a power surge on power cut and at the time I flashed the same openpli image but din not bother to reconfugure it because I had an IPTV subcription, so i left it unconfigurated
The last couple day I have been trying to use it again but i forgot completly how i did it inthe first place, lique a big memory laps.

do I need first to set positioner properly, DISECqC 1.2

I,m completly lost do I need to reset position setting and start again
Hope someone has some spare time and guide me steps to do

Much appreciated

Happy new year to aeveryone
 

ladybreaker

Registered
Messages
5
yes it is
was purchased dec 2008 " dark motor satellite sat dish diseqc usals motorised "

Drive Dish Up 1.4
Very Hight Speed

Protocol : DiSEqC 1.2 & Goto “X” 1.3
Compatible Receiver : Receiver with DiSEqC 1.2 or Interface Box
Antenna Size : 140 cm Max.
Speed : 1.9 / sec (at 13V) ; 2.5 / sec (at 18V)
Azimuth Angle : 80 East ~ 80 West ( 160° )
Elevation Angle : 25~75
Input Voltage : 13 / 18Vdc
Output Voltage : 13 / 18Vdc
Power Consumption : 50 mA (Standby)
200mA (Normal)
350mA (Max.)
Satellite Positions : 60 positi
 
Last edited:
Top