BISS PROVIDER NOT SHOWING ON DIABLO 2

W

westonesat

Registered
Messages
145
hi, to all.
i have just programmed my diablo 2 cam using fausto.
all new providers that i have entered show on cam in list keys when inserted into stb.
the exception is that a biss provider that i have entered does not appear in the biss list, although it is present in keys xml. file.

any help,advice or pointers greatly appreciated.
 
W

westonesat

Registered
Messages
145
Thanks for your quick response.

pltv 10e 2600 000006

this is the only 000006 in my file.
i have now moved it to the first position in the biss list.

it is now showing on the cam in the stb under list keys.

is there a maximum number of biss entries that the diablo can handle?.

thanks for your advice.
 
empb

empb

SU Team: It's All Good (Fausto v1.45/Newcamd/vplug
Staff member
Administrator
Messages
10,270
Diablo only uses the first SID of each key. But yes it only displays a limited number of keys. So if you have 20 x SID: 0001 in the file then only the first one will open the intended channel, which is what the link above (in my previous post) explains in more detail.

BTW There isn't a published active PLTV Biss key at the moment, so unless you have a non-public one from somewhere don't expect the key you are using to work/open anything.

As it already very states in the keys section, If a thread is CLOSED keys are more than likely DOWN:

http://www.sat-universe.com/showthread.php?p=772150#post772150
 
W

westonesat

Registered
Messages
145
i read as you advised in previous thread.

my concern was that i had only one 000006 in my list, and it was not showing on the cam in stb, but was clearly in the xml.

i am aware of no public key atm.

thanks for your help.
 
You must log in or register to reply here.
Top