ro_54
Registered
- Messages
- 685
i have a bunch of emm keys for this tp, but none of them are rolling anymore since last sunday.
PowerVu Chat [only chat, don‘t post keys here]
- Thread starter slugworth
- Start date
Only ECM working at the moment. No data being send by the stream so EMM will not do the autoroll until they do it. You will need to stop in the TP when they do it.
ro_54
Registered
- Messages
- 685
can you share the ecm keys by pm ?
thx.
Some webk groups reporting that same emm keys are working again.
Seems like they are sending data to the stream again.
Excellent
It should auto roll fine with your new keys, if you need more help ley me know.
drakulaboy
Registered
- Messages
- 1
guys, please help me to config oscam only for PowerVu Autoroll on Discovery 12322
Hello
I'm new here, I'm on a different forum.
Looking for help on using PowerVU Emu 3.8.1.
I'm not sure on the setup procedure and options
use for this program. I'm looking for help
to set up a trail run on key decryption using
the options list of why and when to use them.
Thanks
J.G.
I'm new here, I'm on a different forum.
Looking for help on using PowerVU Emu 3.8.1.
I'm not sure on the setup procedure and options
use for this program. I'm looking for help
to set up a trail run on key decryption using
the options list of why and when to use them.
Thanks
J.G.
powervu channels star C one 65
I'm using the powervu emulator 3.8.1 it is been able to get the EMM key but no picture, there is something else I have to do.
this package of channels are Brasilian channels in this satellite futebol, pfc if some body can help me.
please
I'm using the powervu emulator 3.8.1 it is been able to get the EMM key but no picture, there is something else I have to do.
this package of channels are Brasilian channels in this satellite futebol, pfc if some body can help me.
please
Hello
Good to see somebody reads these posts.
I to am looking for set up information about 3.8.1.
powervu emulator nobody seems to document these
software programs your just left on your own.
I will keep plunking away to figure this thing out
but it would be nice for somebody with some knowledge
to step up with a little help.
Thanks JG
Good to see somebody reads these posts.
I to am looking for set up information about 3.8.1.
powervu emulator nobody seems to document these
software programs your just left on your own.
I will keep plunking away to figure this thing out
but it would be nice for somebody with some knowledge
to step up with a little help.
Thanks JG
check PVemu monitor and tell us what modes is using.
It might be something in use that emu cannot handle.
This brasilian sats are always using something to stop PVemu from working.
In the other hand,PVemu function the same it always did,so if you guys been using it before,there is no change.
For the new ones,there is a section in DVB CARDS where you can read about the setup.
Last edited:
ro_54
Registered
- Messages
- 685
check your pm box.