Mvision HD 260 WIFI v.1.0.80 causing receiver to reboot by changing channels

F

ffbtmde

Registered
Messages
17
After installing the firmware f1.0.80 for mvision hd 260
I have noticed that the receiver is rebooting periodically
when changing channels either from menu (ok) or typing
the channel number directly on the remote.

this does not happen if I install the 0.0.80 version of the firmware.

Any Ideas?

Thank you
 
F

ffbtmde

Registered
Messages
17
Hello

is it possible to backup the network application settings
to a USB Stick when performing
a default factory reset of the receiver?

All other settings are backuped automatically, but the network application settings are not backuped to the stick

Thank you for some feedback
 
H

honestman

Registered
Messages
6
even after installing ver.80 I cannot view channels (encrypted) recorded to a pen drive, on a laptop or dvd but only on the original hd260 - there is no problem with free to air channels.

any solution

thanks
 
You must log in or register to reply here.
Top