this will show you how to install usb drivers in you pc
1. Download and install the Flash tools(version 1.0.2) program on your PC
2. AC power Off in the rear panel or press power button and OK button simultaneously on the front panel. (This is to make
Cold Off mode)
3. Connect between your PC and STB with USB Cable
4. AC Power On.
5. Press and keep holding the Power button and press + right direction button on the front panel, and you see “USB
UPGRADE” in the front panel.
6. PC detects new hardware device (important) to INSTALL the USB driver
7. Driver Installation Wizard Appears
8. Select ‘install from a list or specific location (advanced)’ and click ‘Next’.
9. Select ‘Include this location in the search’ and click ‘Browse’
10. Designate the folder at C:/Program files/Flash_tools) and click ‘Next’
11. Wizard will search the driver file.
12. Select ‘USB FOR VESTA – c;/windows/inf/vestausb.inf’ and click ‘Next’
12.1. If it asks system file in some case, Browse at c:/program files/Flash_tools/vestausb and click ‘OK’
13. Click ‘Finish’ when it is done.
Important: The order of this procedure is very important; please do follow the instruction step by step.
When Driver is installed successfully, it is ready to download the latest image to the STB
(use the client usb port ok)
----------------------------------------------------------
after you finnish installation usb driver flow this ,,,this will show how to send the image to ur stb,,,
1. Your STB and PC have to be connected by USB cable.
2. The STB has to be in ‘USB upgrade mode.
* For the ‘USB upgrade’ mode, refer to above Driver installation procedure from 1 to 5.
* Tips to make USB upgrade mode without AC Power ON/OFF or power button + + right direction button.
- If you are watching TV now, press Power button + OK button. This status is same as AC OFF/ON which is so
called ‘Cold off’.
And then, Press and keep hold the Power button + right direction button on the front panel until you see “USB
UPGRADE” on the front
3. Run the Flash Tools
4. Select ‘USB’ and check the “USB connected” in the Message box.
5. Designate the image that you want to download to the STB by pressing FILE
6. Click ‘Down’ and Wait for "DONE" on the front display
* The progress is Downloading -> Erasing -> Flashing
* Downloading time : depends on what image. But in case of ‘usb_all_noboot_db.img, it takes about 10 minutes.
7. Press Power button to reboot. your STB will be restarted
FLASH TOOL IS HERE
http://www.sat-universe.com/showthread.php?p=163587#post163587