Tutorials For ITgate

Status
Not open for further replies.

k@lkov

Super VIP
Messages
10,003
JTAG For ITgate 100/200/220 for Windows
NOTE:
- This program supports Winows NT/2000/XP only as it is using window library “portTalk2.2”
- Go to BIOS Setup utility and check I/O address at Parallel port. If the value is not 378, it should be changed to 378.

1. Make LPT (Line Print Terminal)/JTAG Cable.
2. Download files
3. Install window library (PortTalk) (of the files you downloaded during the process no.2) only if it is the first time.
1) Double click porttalk.reg file and start installation.
2) Please copy "porttalk.sys" at "windows\system32\drivers".
3) Please reboot computer. The “portTalk” runs after rebooting.

4. Connect JTAG/LPT cables
5.Turn iTgate receiver on
6. Run

Using: itgate-write-bootloader.exe [YOUR RECEIVER MODEL NAME]
Code:
C:\ITGATE_jtags>itgate-write-bootloader.exe
===JTAG v2.0 (06/19, 2007)
Using : itgate-write-bootloader.exe [100/100-old/200/220/220-usa]

C:\ITGATE_jtags>itgate-write-bootloader.exe 100
**** CAUTION !!!! **********************************************
* *
* JTAG Flasher for ITGATE TGS100 (REV0.2 2006/03/07) *
* This is "Write Boot-loader" for Window *
* GPL (c) 2006 T-Hydron *
* *
****************************************************************

*** CPU and JTAG communications check ***
LPT/JTAG IO Delay set to 1
Your target CPU seems to be a PowerPC indeed. Let's continue...
Hardware setup ok
*** Flash check ***
manufacturer code: 0x0001
memory size code: 0x2249
Chip erase 0x7FC00000 ...............................................
Flash bootloader
100% done.
Check flash

100% done.

****Flash ok.

C:\ITGATE_jtags>
7. Repeat the process No4. 5. 6 if it is failed.
 

topquark

Registered
Messages
18
If you are making your own jtag lead, keep it short. Less than 30CMS is ideal.

It has also been reported to work more reliably on older PC's. So if you have an old PC around, it may still have a use, so don't throw it out!
 
Status
Not open for further replies.
Top