Solo 2 V1 -> V2 Update issue

Rake722

Registered
Messages
12
Just tried the update to V2 on my Solo 2 Clone,

The USB FPGA update went fine, however the .dat part seems to have issues.

as per the instruction I opened the update.exe and switched on the solo2 and got the correct

"start download..." compliance -

However there were no dots or indication that the update was actually sent to the box.

The cable used had the following pinout -

Plug no 1 Plug no 2
2 ------------- 1
5 ------------- 5
3 ------------- 6

The cable is detected due to update.exe starting the download when the solo starts.

Any help appreciated.
 
Top