CLARKE TECH ET9000 ENIGMA 2

R

ronald68

Registered
Messages
71
CLARKE TECH ET9000 ENIGMA 2

New twin tuner gebased on linux.

Specs;
400MHz MIPS Prozessor
HDTV H.264 Hardware
Ttin Tuner SAT
Linux Enigma 2 OSD Betriebssystem
10/100MBit Ethernet LAN Anschluss
Grafisches 12 Buchstaben VFD Front Display
3 x USB 2.0 Anschlüsse für u.a. externe HDD, Tastatur, Maus, Hub, DVD-Laufwerk
1 x Sata intern für HDD
1 x eSata extern
1 x HDMI Ausgang
1 x YUV Ausgang
2 x Common Interface Slots
2 x Kartenleser eingebaut
Multimedia Video/Audio Streaming über Netzwerk
S/PDIF Dolby Digital AC3 Ausgang
2 Scart (RGB, FBAS oder S-Video)
RS232 Schnittstelle
8MB Separater Bootspeicher (Bootloader kann nicht beschaedigt werden!)
128MB Flash / 512 MB DDR Memory
DiSEqC 1.0/1.1/1.2/1.3 USALS
Media Player
Direkter Plugin Download

price ca. 499 euro.

Have Fun
Ronald68
 
R

ronald68

Registered
Messages
71
Clarke tech ET9000 Compared

Clarke-tech ET9000 Compared with other Linux Boxes
See attachment.

Have Fun
Ronald68
 
R

ronald68

Registered
Messages
71
Compare Clarketech ET9000

Compare Clarketech ET9000:

sshot3x.png


Have Fun,
Ronald68
 
G

grumbles

Registered
Messages
30
and heres me just about to buy a vu-duo,if the supports there this is a slightly better box,yes?
 
E

elgeneral

Registered
Messages
7,811
great receiver but I understand that only the support of PLI is not enough hopefully more teams will give their support

therefore it is better vu+ and also is very expensive 500€ :confused:

I will wait a while to see if you have a good support but I also want to buy

this is what I think :)
 
P

Partybuster

Registered
Messages
53
the hardware is great (even a bit better then VU+ Duo) but I would wait a little longer if I were you to see how the community accepts this receiver. Without enough support on the software side all that nice piece of hardware can be useless for most of the people.

I haven't seen any official development site from the makers. So far only openpli image available, what if they decide to stop...
 
Q

Q-bOxHd

Registered
Messages
163
The box it self is very nice, fast and does what it says on the papper, the problem maybe as other says here , will it have inaf support ?

We remember the Vu+ box, had no support for some time, then some teams started to make images then we see where this box has ended up now, but the CT ET 9000 looks very good on the paper, and by the look of it you can run any DM or Vu+ addon and emu, as long as you know what you do, so i do not see a problem there on support part
 
G

grumbles

Registered
Messages
30
Thanks a lot for your time people,ive waited a while now for a box but maybe just a little bit longer...!
 
R

ronald68

Registered
Messages
71
I Have seen prices of 459 Euro
Till now clarketech support for them other type boxes was not bad so i hope they do the some for this one.

Ronald68
 
A

aqa

Registered
Messages
47
every 1 with one of this box please keep us upto date . i am thinking of getting 1 of this box. i have vu+duo atm . i would like to know how is this box compared to vu+duo especially the pq. so please put all your findings here,,,thanks
 
E

elgeneral

Registered
Messages
7,811
ronald68 said:
I Have seen prices of 459 Euro
Till now clarketech support for them other type boxes was not bad so i hope they do the some for this one.

Ronald68
Click to expand...

I have an even lower price :thum:

HD Freaks planing make Images for this box

but if you are like in vu+, will be based on PLI
 
G

grumbles

Registered
Messages
30
It has pip and the pq is rumoured to be excellent,lets wait and see,i think its about £100 more than the vu....
 
G

grumbles

Registered
Messages
30
My apologies,yes its picture quality,and off another site(dont know if i can mention)yes full hd and cccam.regards,grumbles
 
E

EW79

Registered
Messages
252
we need independent tester.

Looks good but I want box with Freeview HD tuner or slot for this.
 
G

gorski

Registered
Messages
1,553
Normally E2 would recognise the USB DVB-T tuner and you could run it like that...

Tuners are 1080p?

Blindscan [if so HW or SW]?

PnP or on-board?

4:2:2 supported?

Multimedia [streaming to and from the device] fully functional or...?

CS fully working [card readers/server/client sides]? Which Emu's?

Thanx!
 
E

elgeneral

Registered
Messages
7,811
yes gorski the monopoly dreambox is end the last 7 or 8 months

Preview shot, this is a first image with EPG embedded (tnx Skaman).

screenshot_skin.jpg


screenshot_EPG1.jpg


screenshot_EPG2.jpg


screenshot_EPG3.jpg



coming soon

Bye
ClarkeSupport
 
R

ronald68

Registered
Messages
71
gorski said:
Normally E2 would recognise the USB DVB-T tuner and you could run it like that...

Tuners are 1080p?

Blindscan [if so HW or SW]?

PnP or on-board?

4:2:2 supported?

Multimedia [streaming to and from the device] fully functional or...?

CS fully working [card readers/server/client sides]? Which Emu's?

Thanx!
Click to expand...

I am tested this box now for a week:

Streaming -> ok
Cccam -> ok
Picture on flatscreen better than my old CT5000 HD+
Till now i am very pleased with this box

Others test reports:

1:
OK guys, I would say the new driver fixes the issue. My test recoring is now already at approx 7GB, which is way more than I ever had before. I will let it run for some additional time, and then I will do some more tests (parallel recordings, switching channels while recording), but I think it's fixed.

On one hand, I find it totally unacceptable that the box was launched with such a major and obvious bug. On the other hand I am quite delighted that CT provided a fix so fast, having in mind that it's only 1 day ago that I reported this issue for the very first time. This is impressive and makes me believe that future bugs that need to be fixed in the drivers will be quickly adressed as well.

2:
Wow OD! This sounds good. I will switch this evening to 2.0 as well with the new driver. CT is very quick compared with other stb producer. They submitted the informations about the remotecontrol to the Logitech Harmony database very fast. 3 days after my request the database entry was done from Logitech.


The latest "official" builts from et-view.com:

Have Fun
Ronald68
 
You must log in or register to reply here.
Top