storing position diseqc h-h rotor in dreambox 800hd

dejovr71

Registered
Messages
4
The procedure of storing position diseqc motor Dreambox 500HD and 800HD

A: First, the satellite whose position you want to memorises, you find FTA (FTA) channel that works without sharing, and validate with OK and then:
Udjes in MENU> SETUP> OK> SEARCHING SERVICE> OK> TUNER CONFIGURATION> OK> TUNER A; advanced> OK:
Advanced configuration mode
Satellite obelezis the left and right satellite whose position you want to memorises
Lnb lnb 1
Diseqc 1.2 mode


Use USALS for this satellite right arrow switches to NO
Stored position 001
Up Arrow then restored to configuration mode and confirm with OK ...
ZAP BACK TO SERVICE ... ..? should be YES and OK
Press EXIT arrow down one and land on POSITIONER SETUP and OK ...
Put the POSITIONER MOVEMENT AND pressing the red button on the west pomeras engine and pressing the blue button to the east pomeras engine ... then you will find the signal SNR to show a white line figures and percentages in the above figures for the signal strength in dB, BER should be 0 or at least about 0 and the last row LOCK: LOCKED printers ... then down to POSITIONER STORAGE memorises the position of the engine I Write the number on which will be the position of the satellite (tHIS IS VERY IMPORTANT) and press the green button (store position) saves position of the satellites ... then press Exit> yes> OK> EXIT 3x
B: Repeat the operation for each satellite
NOTE: ensures that each satellite post some RAZLICITI POSITION NUMBER IN STORAGE and it is best to write it all down on paper you would not forget
 
Top