How to do auto-update with ITGATE Control Center
***New Control center must be used from now on.(from ver.2.4)
1) Download and Unzip the file below.
2) Run the ITGATE Control Center.
3) Insert & save IP address in the 'Config' section.
4) Press 'Update' button & select the *.img file in the 'Update' section.
5) Autoupdate will be started.
6) Wait until the receiver reboots automatically
How to update TGM 220 by Flashing through serial port
***New Control center must be used from now on.(from ver.2.4)
1) For Serial update, please click hereunder to download the image.
1. Connect the receiver & PC with RS 232 cable
2. Power on the receiver & press CH+ button on the front at the same time repeatedly.
3. You will see the menu,in which there is 'Serial Update' & go to the menu using by CH+/- button.
4. When you cursor located on 'Serial update', press vol+ button
& Press CH- button to start the upgrade.
-----------------------------------------------------
Before the above no.4,
1. run the control centre & go to the 'Serial update' section (you don't need to input IP address)
2. After setup the com port, press 'file' & select the img.file.
After that, you can start the serial update under the above no.4
How to update by Internet
1) Press MENU button on the remote controller and go into " Setup -> Expert Setup -> Software Update -> Internet Update" and select the image.
2) Follow as prompted on the menu.
