4620x went dead after upgrading to 158p

w.majid · Jun 13, 2008

Hello

I just upgraded my 4620x to fw 158p, after sucessfully finished, the receiver shut down and nerver turn on. I had upgraded it several times w/o problem. Anyone can give me a piece of advice what I can do?

Thanks in advance

fetean12 · Jun 13, 2008

an answer for you

when you turn it on if any light appears on the recevier screen that means the firmware uploading was error if there is no light iam so sorry but the ac circuit is burnt and you need to change it

w.majid · Jun 13, 2008

thanks. no light appears. Is it caused by upgrade process?

w.majid · Jun 16, 2008

Hello

I checked the power switch. All power voltages are ok. Does it need reflashing?

hanirahal · Jun 24, 2008

Yes the patch 158 has problem you must download the original software and then download then last patch from this forum

Memento · Jul 5, 2008

Hello

I just upgraded my 4620x to fw 162p, after sucessfully finished, the receiver shut down and nerver turn on. I had upgraded it several times w/o problem. Anyone can give me a piece of advice what I can do?

Thanks in advance

akpojevighe70 · Jul 12, 2008

download 118p it will restore it back.

MEEMNOON · Aug 28, 2008

you must buy a new set

okeme · Oct 18, 2008

I HAVE A PROBLEM after sucessfully finished, the receiver shut down and nerver turn on. I had upgraded it several times w/o problem. Anyone can give me a piece of advice what I can do?