CCCAM upate for TM600

Try install this version mate

http://www.sat-universe.com/showpost.php?p=534855&postcount=27

Ferret

Yes both files tested and used by other members

see here

http://www.sat-universe.com/showthread.php?t=156608

Put receiver in standby and then pull the plug out. Then power back on and retry the mgcamdnewcs file.

If that does not install the image is some how corrupt. Do a factory reset then reinstall the image and start over again. This time you'll know what your doing and things will run more smoothly.

Ferret

Ive just tried all the files here mate with 100% success im at a loss as to what your problem is!

Maybe all you can do is flash the latest version and try that

http://www.sat-universe.com/showpost.php?p=532928&postcount=26

Ferret

Ah so you flashed the latest version when i linked you to this one

http://www.sat-universe.com/showpost.php?p=475350&postcount=22

To get 1 west back do this

Menu-setup-service searching/sat install-sat config

Now press the yellow button a few times you shoul see it adding sats.

Now

Menu-setup-option5 reboot now 1 west should be there. On the blue panel make sure CCcam is running and then send over keys.

As for the mgcamd install are you doing it like this

Press the blue button twice scroll to addons manager. Then press the yellow button for manual install. and on the drop down select mgcamd and then ok

Ferret

To send keys over take a look at this guide, this was done with DCC but just use File zilla as you have that setup

http://www.sat-universe.com/showthread.php?t=132624

Ferret

Here mate

You just need the key bundle

http://www.sat-universe.com/showpost.php?p=537103&postcount=389

Ferret

Use the ones for the emu your have running

Ferret