Multiboot (DuckBA) for Spark 7162 and 7111

WaRp

(∩`-´)⊃━☆゚.*・。゚
Staff member
Administrator
Messages
29,632
DuckBA-E2-plugin

There are two ways to return to the Spark system from enigma2 system
The usual way
Close the device from the power button in the back and Click on the ok from the front of the receiver for 5 seconds, then not leave ok, and
open the device from power button in the back,Until it Appears on the screen is forc supported you from Ok, then you Click on the channel buttons next to it until the word spark appears Click Ok wait a little while Boot appears and the device will run.

The second and best through DuckBA-E2-plugin
open the dcc program
Then send the plugin to tmp without unzip it
go to the plugin menu and open the dream explorer
Or a similar program
go to the tmp field and click OK
find the file click OK
After the installation is completed, will restart the device
After restarting, the plugin appear at the bottom of the menu screen

You can also refer to any version on the external flash
 
Top