Hi Ersin328,yes jtag is 212 and it works again 100% whit bbs .
i reach to get connected on BBS but i think my chip is dead because bad sectors start is writtenHi Ersin328,
i've the same issue with my vu solo pro can you give me some information about how to jtag my box?
i've already BBS working well on a XP computer because i've already done a jtag on a cloud ibox3
Thanks for your support in advance
thanks for your reply ersin328no jtag pins are P212
f bad block start box again
ok thanks i will try this evening like u say3v3 need gnd not need
i've tried but when i plug the pins for 3.3V my cypress board is not recognizedok thanks i will try this evening like u say
I just recovered a cloud-ibox with this jtag interfase.
I first had to solder pins to logic board for the jtag connector on p212. First I tried to read the Thoshiba chip (TC58NVG0S3ET00) but I always got error bad sectors on first block. I tried for few times and tried to erase the chip and that finally worked. I had the firmware on disk so after erase I could program he IC. It took 1.5 hour.
Strange thing I only connected 3 wires did not use no1 or 3.3v.
Hope this will help someone.
can someone tell me how to flash using nfi image please