Hi, perhaps somebody could give me a little guidance on a little problem I've come across,
I am having a little trouble trying to set up two 120s to work with newcamd through my home router (As previously described below)
I cannot seem to make a connection between the boxes, not even a successful ping. I've been able to connect to external newcamd servers in the past so I guess my problem is my setup on the server end of things. Possible solutions I've seen in the past refer to port forwarding settings on my router but this area would be new to me.
I assumed as my server/client info I entered matched (IP Address, port, user, password) I could simply select 'start' on my server box and 'connect' on my client box, but this has not worked.
Any possible solutions would be greatly appreciated (perhaps I am overlooking something very simple). Thanks in advance,
I am having a little trouble trying to set up two 120s to work with newcamd through my home router (As previously described below)
Card sharing over LAN on Ariva based M3606 by NewCamd
Solution support up to 4 client in LAN connection:
Server
1. Change MAC address, save, shutdown restart, and remember to
plug-in card!
2. Set NewCamd Server and press red button to configure.
3. Set server port 8000 (recommended), user name and password.
Default DES key is
01020304050607
08091011121314
4. Press the start button, open the server, button will become a
stop (second press will shut down the server). Do not press stop,
EXIT to main menu or other operations, such as watching television
'''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''Client
1. Change MAC address, save, shutdown restart!
2. Set NewCamd Client and press red button to configure.
3. Enter the server's IP and PING to check LAN connection first.
4. If success than enter port, user name, password, etc.
5. Login and through NewCamd agreement, you can watch TV
In the server side you will find “connect success” it illustrate the success of the client
connections.
I cannot seem to make a connection between the boxes, not even a successful ping. I've been able to connect to external newcamd servers in the past so I guess my problem is my setup on the server end of things. Possible solutions I've seen in the past refer to port forwarding settings on my router but this area would be new to me.
I assumed as my server/client info I entered matched (IP Address, port, user, password) I could simply select 'start' on my server box and 'connect' on my client box, but this has not worked.
Any possible solutions would be greatly appreciated (perhaps I am overlooking something very simple). Thanks in advance,