I've made some major changes to my BDC_ATR_Restorer WinExplorer script.
This will NOT resurrect a card that has been killed with a killer BDC file.
However, it will restore the ATR to a BDC which is stuck in application mode and the Dragon Loader cannot erase or detect it.
You must use a Phoenix Interface, initially at 6.00 MHz, ideally in a "real" rs232 comport. Then, when prompted, change to 3.57 Mhz and run the script again. It works fine for me with a CAS3 interface.
Please give feedback on any success or not.
007.4
This will NOT resurrect a card that has been killed with a killer BDC file.
However, it will restore the ATR to a BDC which is stuck in application mode and the Dragon Loader cannot erase or detect it.
You must use a Phoenix Interface, initially at 6.00 MHz, ideally in a "real" rs232 comport. Then, when prompted, change to 3.57 Mhz and run the script again. It works fine for me with a CAS3 interface.
Please give feedback on any success or not.
007.4