How to program a new Software on GigaTwin Cam with Cas 3
-----------------------------------------------------------------
This guide is only for update the
Software ONLY
-----------------------------------------------------------------
Will need studio 8.3 at this moment with the cas 3
(NOTE Cas 3 planning soon more suppport for this cam)
You will need the dummy card that is coming with the cas 3
1- First connect the dummy card into the giga (dummy card usally has tapeplug with it)
2- Connect the tapeplug in cas 3 by push softly in the base of it
3- Then open cas interface with studio 8.3 & connect it with the usb plug
4- Go to cam modules
5- Click on other cams
6- Click on giga cam
7- When the new window opens browse the file with the software you needing
8- Click down left in window > start programming
9- Need to wait few minutes till see the progress 100%
10- THATS IT........CLICK ON THE WINDOW END
***************NOTE*********************
If the progress stops at 99% DONT WORRY
The Modul Has Done the Job
Is this the 1st programming of your GigaCam, then you must first go into cam menu:
Common Interface --> Setting -->
Parental control: insert [8888]
only now you will see the whole gigacam menu including the "Key Management" (see attached pic)
N.B. Important:
After upgrading to a new FW, you eventually need to go to Cam menu --> Utility --> [KeyReset] ... in order to activate new keys. After that update the latest keys with the latest softcam file!