PORT RS232
1. Connect the PC and the receiver with the RS232 cable, with the receiver without turning it on.
2. Open the "ALIUP. Exe" tool on the PC, choose the COM port that corresponds to each one.
3. Press "Open" to select the correct firmware, select it where you saved it and press "Open".
4. Now the file appears in the "File" menu of the program.
5. Press "Start" and then turn the receiver on to power.
6. In the "Download" menu of the program starting to move a progress bar. When the process is finished, after several minutes, the receiver will reboot.
7. Disconnect the RS232 cable and turn off the receiver's power and turn it on again after 5 seconds.
8. The receiver must be restored.
9. If the process is interrupted at any time or an error message appears in the program, start again at point one and, if necessary, choose the different COM port in the program.