Update:
Its all working a treat with the omnikey 3121 cardman very good response times less then 100ms.
Decided to start from scratch with clean VTI image.
1) Install the drivers for Omnikey reader there on this forum :thum:.
2) Install oscam & cccam from plugins menu.
2) look at the oscam config files in /etc/tuxbox/config make changes where needed.
This is from my oscam.server config
[reader]
label = Omnikey Reader 0
enable = 1
protocol = pcsc
device = 0
services =
pincode = 1234
caid = 0BAA
detect = cd
mhz = 500
cardmhz = 357
ident =
group = 1
ecmcache = 1,3,2
this is from my oscam.conf
[global]
logfile = stdout
disablelog = 0
disableuserfile = 0
usrfileflag = 0
clienttimeout = 5000
fallbacktimeout = 2500
clientmaxidle = 120
cachedelay = 120
bindwait = 120
netprio = 0
clientdyndns = 0
resolvedelay = 30
unlockparental = 0
nice = -1
serialreadertimeout = 1500
maxlogsize = 10
waitforcards = 1
preferlocalcards = 0
saveinithistory = 1
readerrestartseconds = 5
readerautoloadbalance = 0
readerautoloadbalance_save = 0
resolvegethostbyname = 0
[newcamd]
port = 35000@0BAA:000000
key = 0102030405060708091011121314
allowed =
keepalive = 1
mgclient = 0
[webif]
httpport = 8888
httpuser = user
httppwd = password
httprefresh = 5
httpallowed = 192.168.1.1-192.168.255.255
httphideidleclients = 0
httpreadonly = 0
Make sure everything is working as it should.
Using
http://Your_Box_IP_address:8888 in web browser
Please note the latest oscam release is not downloaded from the plugins. Then stop the cams and using ftp program replace the oscam program which was installed via plugin menu with the very latest one from this forum.
Now you will need a line in your cccam.cfg
# tring card on this box #######
N: youIPaddress 35000 user password 01 02 03 04 05 06 07 08 09 10 11 12 13 14
Now you can start your cams from the plugin menu and give it a try.
Bonus these reader are less then half price of smargo
Hope this helps someone