C
costa46
How To Program an XCam
Enjoy.
Downloading Main Program
1. Install and open the proggy Xcloader.
2. Select the download file and set the block item to Block2.
3. Press the connect buton.
4. Now go to your receiver and select Update item from CI menu.
5. Press “OK” to Activate loader
6. Wait until ‘Transfer Done!’ message on Xcloader program appears.
7. Shut off receiver even when it's not giving you the message it's finished.
8. Put on receiver, go into the CI-menu again, go to settings and select “default Key”.
9. Enjoy!
Downloading new Key Table
1.Select the key table file(softcam.key) and set the block item to Block14.
2. Press Connect button, then the following message will pop-up:
3. Now go to your receiver and select Update item from CI menu.
4. Press “OK” key of to Activate loader
5. Wait until ‘Transfer Done!’ message on Xcloader program appears.
6. Shut off receiver even when it's not giving you the message it's finished.
7. Put on receiver, go into the CI-menu again, go to settings and select “default Key”.
Enjoy.