CILQUER ICI

bjolly · Jul 2, 2010

Hi,

I have followed all the directions set out and although the comms and internet is connected and ok, I cannot get it to work. Do I have to do anything else Vplug is active.

Regards

BJ

Technomate 5400 CI+

COMPASS · Jul 2, 2010

1.what comport does your pc use to connect to your receiver?
2. did you activate sssp in tm menu ?

regards

bjolly · Jul 4, 2010

Tanks for your help.

I am using comport 3 (manually selected) I can upload and download to stb, but I mainly use USB for this.

Yes sssp is selected

bj

COMPASS · Jul 5, 2010

open mpcs.conf using Notepad

you will see the following

[serial]
Device=au://tuner@/dev/ttyS0

ttyS0 = COM1
ttyS1 = COM2
ttyS2 = COM3
ttyS4 = COM4

Please change exit and save (you will need to do this procedure whenever i post an update)

regards

bjolly · Jul 5, 2010

Thanks,

I have just checked and I have com port 1 set up as your prog uses ttys0.

downloaded new prog and ran it as above and still nothing. do I need to add server ?

regards

bj

bjolly · Jul 5, 2010

Oh after a while it disconnects my stb until I change channels

alans220 · Jul 6, 2010

Hi,

I'm having the same problem.
Connected to com1 ok, uploaded latest patch using Loader.
Downloaded and run the Clickerici, the one for themex/jsc/bulsat
Ran the spbl, activated vplug.
Went to 39E, changed channels, back to JSC, nothing.
sssp is enabled on receiver
Downlaoded and ran wsp, not sure what to do with it.
Any help much appreciated.

thanks

al

bjolly · Jul 15, 2010

Doesn't look like anyone can help does it !