Search results

  1. Y

    Kabelio on 13E

    Thanks for the info!
  2. Y

    Kabelio on 13E

    Good to know as i hope to get the card working in my 5402 M3. I was going to get a Technisat DigiPlus UHD S-2 but both Kabelio and Technisat have responded saying the unit is currently incompatible. Is it possible to record with the Technomate while watching a different channel and/or to record...
  3. Y

    Kabelio on 13E

    LNB 90 degrees out - fixed now!
  4. Y

    Kabelio on 13E

    I managed to locate and tune the Hotbird 13E Satellite and now have the Kabelio channels. They are showing as V polarisation rather than horizontal. Could it be that my LNB is 180 degrees out of position? Would that cause the inverse reception. The TP reads at 97% Signal and 92% quality. Thanks
  5. Y

    Kabelio on 13E

    Thanks for the info! A reverse channel look up indicates I'm on Astra 19.2E I thought I was on Hotbird 13E as on the channel list there were lots of hotbird channels listed!? At least I know where I am pointing and can search afresh for Hotbird13E!
  6. Y

    Kabelio on 13E

    When I put the Kabelio frequency in the receiver on a frequency search - Zilch. I only have receiver based metering no satellite meter. The receiver metering is responsive and will show even a low signal if it is there. I would guess it is a receiver based issue as I would be surprised to get...
  7. Y

    Kabelio on 13E

    Thanks for the advice. I have tweaked the position of the dish and optimised the skew on the LNB. I did another blind scan and got over a thousand TV channels but unfortunately no Kabelio on 10.853. I'm receiving feeds on adjacent frequencies that are showing 97% Signal Strength and 97%...
  8. Y

    Kabelio on 13E

    Just looking for a little assistance to help locate the Kabelio channels. After the SatBack service ended I repositioned my dish to see if I could receive the Kabelio feed. I have locked onto the Hotbird 13E satellite and following a blind scan have 300 odd TV channels but the scan does not...
  9. Y

    New user from Portugal

    Hi, First a thanks to all those who give generously of their time and skills to guide people like me through otherwise impossible to sort out software/hardware issues. I have an IceCrypt S 1600 CHD SE which is working OK but being a little temperamental! and a (just purchased) Technomate 5402...
Top