Recent content by dogsear

dm500 with marwensat2.4 image.i cannot connect to btkcam server.it did work for one day then stopped.i did not change anything. also spcs 2.5.78 image is looking for a 20 digit access code any idea where i can get one.i tried free but jumps back to needing 20 digit code.these are small probs as...

setting up a mates opticumx7.used to dreambox using dcc to add clines.is there anything similar for the opticum?or do i do it manually with remote.also can someone confirm the latest firmware for this box i think i have the right one i just dont want to brick his box.thanks.

just got tm500super.set it up on 60cm fixed dish.snr and agc showing in 90s.showing lock and sync.but when i go to scan no channels found comes up.this is on 28.valid tps in list.and my other box works fine on this dish. tried it on a mates 80cm dish 0n 28 same thing. this was with orginal image...

new tm 500 in post.have experience using tm3000.from reading posts am i right in thinking that i can load first image using tm loader and ernet cable only.not the 232 cable.or is that only for updating after first image is loaded using 232 cable.thanks for any help.

iam irish with a 80cm dish just moterised which easier to do than made out or maybe just luck on my part.a kaon box with diablo 2.3 in sitting room.a strong 4355 in bedroom with another diablo 2.3.diablo did not work in strong first updated software in strong box now working fine.thinking of...