SSR/SRG Swiss 13E Open Via All EMUs** eg vplug, oscam, mgcamd... (**where Via2.3 is fully supported)

Status
Not open for further replies.
C

Checkershome

Registered
Messages
5
Just a little update:

I fear Via 2.6 won't be open for too long now!
My original Via 2.6 card is still working till end of month (31.07) but my new Via 5.0 (yes, no Via 6.0!) has already been delivered and installed.
So I have to assume that the card-change is already deep on its way and it won't be too long now till EMU will be done - unfortunately! Enjoy while it still lasts!
 
P

Pernambuco

Registered
Messages
154
Robinson74 said:
Could it be that I was missing the following for Oscam Emu?
023810 08
Click to expand...
Keys:
;--- SRG (13° E)
V 023800 D1 0B..B8 ; Des1_Key
V 023800 X1 3D..30 ; XORArray
V 023800 P1 03..06 ; PermArray
V 023800 C1 DA..3B ; ChainArray
V 023800 08 95..BF
V 023800 T1 49..55 ; 23/03/2014 12:20:56
Click to expand...
You don't need keys if you use: OSEmu or oscam_Emu_2in1 with inserted keys.
 
R

Robinson74

Registered
Messages
558
I am using the same keys and all SRG opened except for SRF Info HD. It opened with OscamYmod but not with Oscam Emu.
Now SRF Info HD is FTA so I can't test any more.
 
N

neorafix

Registered
Messages
2
Some of You sent me private message, but I can't reply, because I've written to less posts so far. I use Ferguson Ariva 250 Combo with new soft (version 1.27B3_patch). Digiturk, Viasat (NRK & SVT channels), NT1 (from Canal Sat), BISS channels and some others work fine. I'm trying to open SRG/SSR using key: 023800 08 955.. KEYS ARE ONLY POSTED IN THE KEYS SECTIONS..DBF, but I always see black screen.
 
M

mathey

Registered
Messages
13
It doesn't work with Ariva built-in emu. There are wrong transform table keys inside the software. You could use vPlug server + cccam or a Funcard to get it work.
 
V

vayahoras

Registered
Messages
1
For me, since a few days, it does not work. May be I changed something ... but I do not remember doing that.
 
J

julienr18

Registered
Messages
2
Can anyone help me? After introducing Viaccess PC 6.0(CaID 0x0500 ProID 0x060200) on SGR, Fausto 1.45 still wait on "ECM incoming" and vplug server 1.0.2.21 cannot resolve it. How can I give priority to 023800 ProID ? (CT-5000C)
Thank's in advance
 
S

spiritfree101

Registered
Messages
8
@ julienr18
Hi, I have the same problem.
At this moment I cannot try it, but you could try this:
Open Fausto, choose "Monitor" tab and right-click;
In ECM/DCW try to swap the priority from ECM/DCW to DCW/ECM.
 
Status
Not open for further replies.
Top