Echostar - Echolink Chat

K

kasrola

Registered
Messages
380
Help Please!!!!!!!!Starsat SR-x6300USB.
My new box stuck since I first flashed it, and i have not saved a Original Dump to use it in case of a problems like this occured.
What I am asking is:
1 - used Boot_ON_Error Solved By Nadim, it gives me "failled to Burn Data", enen when burn success still stuck "ON/RUN".
2 - tried some Original Dump for ZETA from this forum with Different upgrade_Tools 2.0.0b/2.0.0C, gives me "Fail to burn/ Rebooting Burn Error"
3- tried SoftCleaner by MAROKINO, did not solve the problem.

Now the box is Blinking between "ON" and "RUN" when switched On.
Back to you experts for some help or any good loader for Dump or ...etc
many thanks
 
mohammed tanko

mohammed tanko

Super VIP
Messages
4,862
kasrola said:
Help Please!!!!!!!!Starsat SR-x6300USB.
My new box stuck since I first flashed it, and i have not saved a Original Dump to use it in case of a problems like this occured.
What I am asking is:
1 - used Boot_ON_Error Solved By Nadim, it gives me "failled to Burn Data", enen when burn success still stuck "ON/RUN".
2 - tried some Original Dump for ZETA from this forum with Different upgrade_Tools 2.0.0b/2.0.0C, gives me "Fail to burn/ Rebooting Burn Error"
3- tried SoftCleaner by MAROKINO, did not solve the problem.

Now the box is Blinking between "ON" and "RUN" when switched On.
Back to you experts for some help or any good loader for Dump or ...etc
many thanks
Click to expand...

USE UPG.PROTOCOL V2.O
LOAD THIS FIRMWARE ABOVE
(LOAD ALL CHUNK) AND LET
IT BURN FLASH.
WAIT A MOMENT, IF IT DOESN'T
BOOT TURN IT OFF AND ON AGAIN
YOU ARE DONE! :thum:
 
You must log in or register to reply here.
Top