- Messages
- 10,198
Code:
Where:
is a script that must run in a dgs / sif with pen or usb hard disk "preparation" firmware automatically from dgs / sif. If you insert a memory stick (or hard disk) formatted in fat32 on this decoder is divided into two partitions (sda1 and sda2) and what they need. The script does not create partitions.
What you need:
E 'need an FTP program and telnet then the decoder must be connected to the network and reachable from the PC.
As:
We need to unpack the files you find in eis.sh attached file and copy it to / tmp to the receiver, change the permissions of the file 755 and key eis.sh. The script will guide you step by step to the creation of the device. Once you install the finished multibooting for your decoder and Enigma2 will be yours.
Cautions:
The script formats the partitions on the device or usb hdd to the choice, so be careful to make backups of your data that may be present on these devices (films, photos, music, etc..).
Test:
the script has been tested many times on my ipbox91HD a decoder, but other decoders IpboxHD should not differ. Report any differences so as to bring about improvements to the script.Thanks ipbox2008