You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
dm500
- Thread starter thomask76
- Start date
chikung313
Registered
- Messages
- 21
So works for me ..
If possible save settings whith DreamBoxEdit before ...
0) Unplug dec from A.C.
1) Open DreamUp
2) Select Com Port
3) Press Connect tab
4) Connect to A.C. and switch-on dec
5) Dec should be recognized (in Progress : Box attached and ready)
6) I suggest flash erase 2 times
7) Press Flash and select Image
8) Confirm flash erase during process
9) Disconnect and close DreamUp
10) Disconnect dec from A.C.
11) Connect dec and switch-on
12) Follow instructions on OSD
13) Select Sat config
14) Select Communication Setup
15) Send settings whith DreamUp
Hope it helps ...
:thum:
If possible save settings whith DreamBoxEdit before ...
0) Unplug dec from A.C.
1) Open DreamUp
2) Select Com Port
3) Press Connect tab
4) Connect to A.C. and switch-on dec
5) Dec should be recognized (in Progress : Box attached and ready)
6) I suggest flash erase 2 times
7) Press Flash and select Image
8) Confirm flash erase during process
9) Disconnect and close DreamUp
10) Disconnect dec from A.C.
11) Connect dec and switch-on
12) Follow instructions on OSD
13) Select Sat config
14) Select Communication Setup
15) Send settings whith DreamUp
Hope it helps ...
:thum: