help plzzz flashing failed (002 crc failed)box will be unusable now
- Thread starter laverman
- Start date
another crc 002 failure on dm800
i have used the version 1.3.3.2 and it worked up to uploading the image to the dm800. when it wanted to install it from the machine then it said that there is failure crc 002 so the image was loaded successfuly .but the execution within the machine was not.
help please i am tearing my hair off.
i have used the version 1.3.3.2 and it worked up to uploading the image to the dm800. when it wanted to install it from the machine then it said that there is failure crc 002 so the image was loaded successfuly .but the execution within the machine was not.
help please i am tearing my hair off.
- Messages
- 17,525
Reflash the same but make sure the image your flashing matches the version of the sim your using.
Ferret
open the box, move your Sim and close
http://www.sat-universe.com/showthread.php?t=141826
diffrent method
and then use the enforcer ...enable..
starting dreamup in folder diffrent method
connect.
and send new image flash..
http://www.sat-universe.com/showthread.php?t=141826
diffrent method
and then use the enforcer ...enable..
starting dreamup in folder diffrent method
connect.
and send new image flash..
Last edited:
- Messages
- 17,525
Look at this thread it shows you the 4 types of sim you may have
http://www.sat-universe.com/showthread.php?p=727874#post727874
Have a look in your 800 with the front facing you and you will see the sim match it to the pictures and then use the correct image.
Ferret
http://www.sat-universe.com/showthread.php?p=727874#post727874
Have a look in your 800 with the front facing you and you will see the sim match it to the pictures and then use the correct image.
Ferret
- Messages
- 17,525
If its a red sim its Ferrari !
flash through http when you get 002 crc failure
I have managed to flash my dm800 through the web interface it was easy fast and simple i would like thank you guys at the forum for helping you are life savers
i guess it was probably an rs232 issue may be cab ling or as you mentionned the nand flash i will never know. this is to show there is light at the end of the tunnel
Many thanks guys!!
I have managed to flash my dm800 through the web interface it was easy fast and simple i would like thank you guys at the forum for helping you are life savers
i guess it was probably an rs232 issue may be cab ling or as you mentionned the nand flash i will never know. this is to show there is light at the end of the tunnel
Many thanks guys!!