E2 pkt 060,9000 disecq problems

Are you using disque & vbox?

Is that the one where u enter long & lat,(usuals) for your area

I use vbox positioner with mine

Go to Menu,set up,service searching, tuner configurataion

Should show your two tuners , ie both sat or sat & cable for example

If tuner A is for sat press ok & set configuartion to 'advanced'

Set LNB to LNB 1 -then scroll down page & enter your settings accordingly - enter settings for each sat you wish to use & press ok to save & exit

Dont forget to select diseqc to 1.2 to access long & lat settings

Good luck

did you sort this, as i have set my motor to the following

configuration mode - advanced
Satellite - Astra 28.2e
LNB - LNB 1
Priority - Auto
LOF Universal LNB
Voltage mode - Polarization
Increased Voltage - no
Tone Mode - Band
DISEqC mode - 1.2
Toneburst - None
Committed DISEqC command - None
Fast DISEqC - no
Sequence repeat - no
Command order - committed,toneburst
Uncommitted DISEqC command - None
DISEqC repeats - None
Longitude - 001.377 west
Latitude - 052.973 north
Use usals for this sat - Yes

I have also sent catseyes settings over by dreamset, however i can still only view 13&19e

cheers

i now have it working thanks to catseye