Adriatic22
Senior Member
- Messages
- 216
Your receiver DM 7020HD is OE 2.0
This is the last version of oscam with static libcryto, should work with all the mips receives.
I created that ipk file for oscam emu and I need somebody to test it on blackhole image.
I need to know if after instalation, oscam start or not.
Thx
It's not so much as needs a particular version of libcrypto to run, just that it has been coded to look for a particular version. Newer versions should work.
If I remember correctly, the ssl version used in images was increased owing to a vulnerability. Pretty sure most images use 1.02 now.
You can try adding symlinks
ln -sf /usr/lib/libcrypto.so.1.0.2 /usr/lib/libcrypto.so.0.9.7
ln -sf /usr/lib/libssl.so.1.0.2 /usr/lib/libssl.so.0.9.7
ln -sf /usr/lib/libcrypto.so.1.0.2 /usr/lib/libcrypto.so.0.9.8
ln -sf /usr/lib/libssl.so.1.0.2 /usr/lib/libssl.so.0.9.8
ln -sf /usr/lib/libcrypto.so.1.0.2 /usr/lib/libcrypto.so.1.0.0
ln -sf /usr/lib/libssl.so.1.0.2 /usr/lib/libssl.so.1.0.0
Maybe add to postinstall script?
I created that ipk file for oscam emu and I need somebody to test it on blackhole image.
I need to know if after instalation, oscam start or not.
Thx
I think people should try to learn a bit about adding start and stop script lines.
Is not difficult and would only require to open a file (inittab) and add some text in specific format.
In this way,Oscam always start at powering up.
I didn't see any note in all the latest releases asking to do it. So I assumed everything was as always till 11518; If is required from now on I don't see a problem if little instructions are stated same as the OE opkg/ dpkg install/ remove instructions.