The procedure for uploading a new Loader Octagon
What will we need?
- The department by rs-232 null modem cable
- Putty
- Loader_usb_octagon.bin - a new loader for our acetate
- Pendrive to FAT partition
Proceed to the fun.
1. We connect the tuner via RS-232 with our computer and run on it or putty hypeterminal
2. Configure Putty to communicate with our a PC:
- Connection type: Serial
- Speed: 115200
3. Turn off the power behind our Tuner
4. Tuner and run quickly to the terminal a few times we click enter to stop the boot process:
U-Boot 1.1.2 (Jun 15 2009 - 12:00:39) - st2.0-14
0 * FrTs
STi710x>
5. Copy your new loader_usb_octagon.bin directly on the flash drive partition
6. PCta remove the pen and put a USB interface to the front of our models supported
7. Begin the process of exchange loader in hyperterminal type the following commands:
Code:
Select all
usb reset
fatload usb 0:1 a5000000 loader_usb_octagon.bin
protect off 1:0-23; erase 1:0-23; cp.b 0xa5000000 0xa0000000 $ filesize; protect on 1:0-23
NOTE: If there are errors we will not disable the tuner, but trying to repeat the operation until it succeeds.
An example of correct installation log is as follows:
STi710x> usb reset
(Re) start USB ...
USB: scanning bus for devices ... 3 USB Device (s) found
scanning bus for storage devices ... 1 Storage Device (s) found
STi710x> fatload usb 0:1 a5000000 loader_usb_octagon.bin
reading loader_usb_octagon.bin
.........................
262,787 bytes read
STi710x> protect off 1:0-23; erase 1:0-23; cp.b 0xa5000000 0xa0000000 $ filesize; protect on 1:0-23
Un-Protect Flash Sectors 0-23 in Bank # 1
........................ done
Erase Flash Sectors 0-23 in Bank # 1
........................ done
Copy to Flash ... . done
Protect Flash Sectors 0-23 in Bank # 1
........................ done
STi710x>
8. If everything goes according to plan we can execute reboot
At the moment there are 2 different loadery:
- Loader, which allows for loading e2 with USB Flash Drive
- Loader, which allows the loading of e2 when we installed the USB SATA drive Presets
WARNING!
Uploading loader operation is dangerous and can damage the tuner!
PKT can not be held responsible for this situation!
Gracias a
djcrash