Meter Instructions And Manuals Only - Please!

satelliteman

Registered
Messages
97
satlook micro+
here is instruction manual + how to upgrade firmware.
have manual in french, german and swedish for those interested just pm request

plus in folder tools you'll find the firmware uploader, data uploader, the latest firmware and as a bonus my own data list (zac1) where once downloaded to your satlook micro will give you satellites list when you go to match==> prelist in arc order from east to west (someone said it can not be done, well here is proof)
 

satelliteman

Registered
Messages
97
needle meter

before aligning dish read how to install a motor first..
making sure you put the latitude and longitude and the elevation of the motor first then go to thor on the receiver
1. put receiver on bbc world on thor
2. put the meter where the motor would be between the receiver and lnb
3.turn the knob so the needle is about centre
4. align the dish as described in the install section by rotating the motor unit round the pole and elevation by the dish, once the needle rises check your tv if you got bbc world on, if so go back to your dish turn the knob down again so the needle is centre again and realign your dish again till the needle is as high as you can get it
5. if not bbc world on tv screen go past that signal until needle rises again and repeat 4
5.tighten the adjustments,replace your cables into the motor

the same applies to any fixed satellite dish as well,just put it on a free to air channel
 

xxxAxxx

Super VIP
Messages
1,172
hmm ..but there's a connection inside if take out the case of the meter (rs232) but i think there's no public tool for it... thanks any way for the replay
 
Top