Engine configuration:
*Let's talk about the configuration of the engine using a manual or automatic positioner (It means connected to your receiver)
But first you must know the position in space, in another sense, be aware the positions of satellites in space.
This is a representation of the relative positions of several satellites:
Arabesat (26°Est), Eutelsat 2 F3 (21,5°E), Astra (19,2°), Hotbird(13°E),AtlanticBird (5° west), Nilesat (7° O)
*Your satellite dish is installed, your positioner is connected to your engine, and it is on, and we are positioned on Astra, *remember it was an example*.
MANUAL POSITIONER
1-If you have a manual positioner:
STEP 1:
-Press the main menu of the Remote controle.
-Choose settings in the selection
-research programs
- Then choose Settings Satellite:
Next go top in the window and select: Many satellites via DiSEqC Rotor.
Several satellites will appear, choose the satellite that you don't want to install to erase.
By pressing each time the red button, and save using the green button, then exit.
STEP 2
Choose the viewfinder window satellites (SATFind)
The "satellite finder window''opens:
STEP 3
*since you are in the correct position of Astra
- You'll notice that SNR is checked in BLOQUE and AGC is checked in SYNC and BER is zero.
- save by choosing a number on your positioner that position (4) for example.
- In the same window go to the list of (satellite) scroll down and select the satellite precedente or the next. (Hotbird 13 ° Eutelsat 2 F3 or 21.5 degrees and you are on Astra 19.2 degrees)
- Note that BLOQUE and SYNC are deselected and that BER is not zero.
Suppose you have chosen Hotbird must move to the West, you select the button of your positioner which moves the motor to the west and make successive small pressures and interrupted, looking at the viewfinder until you see BLOCKE and SYNC are disabled and BER = 0.
STEP 4
So remember as a number (3) in the positioner.
If you went on the next satellite, you do the inverse it means you go to the East with your engine and do the same process, and repeat until the last satellite of your choice to install.
*For example SATFIND f when the engine is not on the position of the satellite selected.
AUTOMATIQUE POSITIONER
2- If you have an automatic positioner connected to your receiver
Perform STEP 1
Then in the search box programs,
Select motor parameters,
*A window opens,- press the blue button on the remote...
Another window opens:
- select "Next" using the blue button:
- Read and run step 3, with the difference to move your engine, you must go to direction on "Stop" and use the arrow keys (right and left) of the remote, and to memorize the position of the satellite, press the button Green and assign an N°:
*your positioner is configured.
