johnsiddle
Registered
- Messages
- 3
Hi Guy's.
I am trying to re-image a DM800HDSE v2 with a new image using my web browser.
Every image I tried reported a bad architecture.
I then found it flashed up No CA and went into stop mode, run flashup.
I have tried dreamup and Sunray flash up but when I switch the box on after flashup say's conection made, neither of the flashup programs respond with the box type and neither uploads the uploader program.
It just sits there in Stop mode.
The web browser info says it has bootloader #88.
Its as if the service port is not talking even though the virtual comms port is set up OK.
Any clues anyone????
I am trying to re-image a DM800HDSE v2 with a new image using my web browser.
Every image I tried reported a bad architecture.
I then found it flashed up No CA and went into stop mode, run flashup.
I have tried dreamup and Sunray flash up but when I switch the box on after flashup say's conection made, neither of the flashup programs respond with the box type and neither uploads the uploader program.
It just sits there in Stop mode.
The web browser info says it has bootloader #88.
Its as if the service port is not talking even though the virtual comms port is set up OK.
Any clues anyone????
Last edited: