dreambox 7080hd and stab motor hh120

-Horst-

Registered
Messages
4,569
On Positioner menu in your receiver, select DiSEqC 1.2 Then select "reference position" or in some receivers it is called 0-position. The motor will move to 0-position and reset. In the case of Satcontrol motor, it will move all the way to East then move to 0-position.
 

bmb1425

Registered
Messages
90
thanks for your reply

i used that way(in dreambox GO TO 0) but the motor doesnot move although the motor is new . the motor was working but suddnly stopped
 

mdt

VIP
Messages
905
remove the power from the motor for 5 mins as this usually re-sets the sat-table ect.
 

bmb1425

Registered
Messages
90
it doesnot work is there any way to reset stab motor hh120 (the motor has no buttons to reset it) and function GO TO 0 doesnot work.
 

Ferret

Marching On Together !
Staff member
Administrator
Messages
17,480
There is no reset on the stabb other than removing the power.

This seems like the stabb could be faulty or the fconnector joint need redoing, you could also check continuity of the coax and the voltage seen at the motor side of the coax. Do you have another receiver you could try on the motor.
 
Top