You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Motorised Dish Settings
- Thread starter Adam1
- Start date
Jan Gruuthuse
Registered
- Messages
- 55
Code:
http://www.dishpointer.com/Latitude: 53.5729° (53.6°N)
Longitude: -2.8558° (2.8°W or 357.2 / 2.9°W or 357.1 ) depending your receiver input. If you use usals use 0.8°W as your reference satellite
Jan Gruuthuse
Registered
- Messages
- 55
Diseqc is a way to control motorized dish.
Usals is a program in the receiver that uses above diseqc
with usals you have to point the dish to 1 sat position 0.8°W in your case. If mounting pole is 100% plumb on 360° and dish elevation is set correctly, the USALS program can guide the dish to each location.
Diseqc: you need to manually program each location.
1st choice: USALS if your receiver supports it.
otherwise Diseqc 1.2 (1.0 & 1.1 switch & fixed lnb)
Usals is a program in the receiver that uses above diseqc
with usals you have to point the dish to 1 sat position 0.8°W in your case. If mounting pole is 100% plumb on 360° and dish elevation is set correctly, the USALS program can guide the dish to each location.
Diseqc: you need to manually program each location.
1st choice: USALS if your receiver supports it.
otherwise Diseqc 1.2 (1.0 & 1.1 switch & fixed lnb)
Diseqc is a way to control motorized dish.
Usals is a program in the receiver that uses above diseqc
with usals you have to point the dish to 1 sat position 0.8°W in your case. If mounting pole is 100% plumb on 360° and dish elevation is set correctly, the USALS program can guide the dish to each location.
Diseqc: you need to manually program each location.
1st choice: USALS if your receiver supports it.
otherwise Diseqc 1.2 (1.0 & 1.1 switch & fixed lnb)
Ok, so usal is a better option, but if the dish is not aligned accurately, will diseqc be a better option?
Jan Gruuthuse
Registered
- Messages
- 55
yes, usals has to be spot on, diseqc you can deviate and save each location separately .
Jan Gruuthuse
Registered
- Messages
- 55
Dish alignment to your satellite south is not dead on?
Dish pole is not 100% plumb on 360°?
When installing dish the motor was not 100% on dial position 0?
...
Dish pole is not 100% plumb on 360°?
When installing dish the motor was not 100% on dial position 0?
...
Humaxfreunde
Registered
- Messages
- 2
its ok made?