Information

weber64

Registered
Messages
55
Hi everyone, I wanted to know what procedure to send the file with some c-line strings to the Tecnhomate 5402.
 

barney115

Donating Member
Staff member
Administrator
Messages
24,682
When on a FTA Channel Press '8281' on remote control
Connection '0' press ok
Change Protocol to CCcam
insert C line information when finish press Exit
Message 'Settings were Change Do you Wish To Save ? "
Select on YES then press RED Button on Remote to Connect
That is all you should see connection Green and ONLINE Connected message , if not go back into Connection '0' and correct your mistakes and Exit & Save again .
Good luck : )
 
Top