Aiuto bootloader su Amiko Mini combo HD

Acherone

Registered
Messages
13
Sarei grata se qualcuno potesse aiutarmi. Devo aver caricato ultimamente qualche firm che mi ha manomesso il bootloader infatti non mi permette più di fare Downgrade. Ora vorrei provare altri firm, tipo Lavatronic mi da' sempre l'errore di bootloader.
Tutto questo da Pennetta USB. Una volta mi pare di aver letto che si poteva tentare qualcosa da PC ma il problema è che non ho una porta seriale. Come posso fare? Vi ringrazio anticipatamente di cuore.
 

iomeali

Registered
Messages
3,962
Sarei grata se qualcuno potesse aiutarmi. Devo aver caricato ultimamente qualche firm che mi ha manomesso il bootloader infatti non mi permette più di fare Downgrade. Ora vorrei provare altri firm, tipo Lavatronic mi da' sempre l'errore di bootloader.
Tutto questo da Pennetta USB. Una volta mi pare di aver letto che si poteva tentare qualcosa da PC ma il problema è che non ho una porta seriale. Come posso fare? Vi ringrazio anticipatamente di cuore.


non ho il tuo decoder, ma

per la mancanza di porta seriale puoi acquistare un convertitore/cavo che porta da usb a port com seriale.

e seguire poi l'istruzioni date da @amebasu
 

Acherone

Registered
Messages
13
When you have problem with bootloader, load firmware with nullmodem cable ! That is the best way ! Use Super AiO Toolbox For All Amiko SD-HD & Alien 1-2 by Dekolte http://www.sat-universe.com/redirector.php?url=https://www.sendspace.com/file/rfwlub

Thanx. U know how i can make this cable null modem? I mean if a can see a pic for know pins contact...
I suppose 1 connector is rca Jack and other is 9 pin serial connector. Just i have to know what i have to connect... THanx and sorry for my bad english...
 

amebasu

Registered
Messages
85
amiko-mini-hd-redukce-rs-232-1.jpg


I dont know pinout, I get it with receiver :(
I FOUND ON INTERNET :

Female RS232 to 3.5mm Jack Cable
Cross over pin configuration
Fully moulded
Ideal to use to 'flash' Programme Free to air boxes from master box or PC
Ideal to use to repair 'bricked' or 'dead' boxes
Used for Amiko boxes with 3.5mm jack in order to repair or flash them.
Pinout schematics:

3.5mm Jack RS232

1st ring(tip)--------------------Pin 3
2nd ring------------------------Pin 5
3rd ring------------------------Pin 2
4th ring------------------------Pin 5
 
Last edited:

Acherone

Registered
Messages
13
amiko-mini-hd-redukce-rs-232-1.jpg


I dont know pinout, I get it with receiver :(
I FOUND ON INTERNET :

Female RS232 to 3.5mm Jack Cable
Cross over pin configuration
Fully moulded
Ideal to use to 'flash' Programme Free to air boxes from master box or PC
Ideal to use to repair 'bricked' or 'dead' boxes
Used for Amiko boxes with 3.5mm jack in order to repair or flash them.
Pinout schematics:

3.5mm Jack RS232

1st ring(tip)--------------------Pin 3
2nd ring------------------------Pin 5
3rd ring------------------------Pin 2
4th ring------------------------Pin 5

THANX! I think in this way i can make a cable. If i dont find rca jack i will open box and solder wire direct. I hope i dont destroy all: my boyfriend say that i am a ruin for him! :)
:thum:
 
Top