VU+ Solo2 Clone FPGA Update

Status
Not open for further replies.

Ferret

Marching On Together !
Staff member
Administrator
Messages
17,480
This update will allow V1 Solo2 clone owners to run unpatched original images.

The update needs to be done by Rs232 only.

Read the instruction in the file.

STEPS:First do the FPGA upgrade as per the instructions in file.once upgrade is complete press okay and a menu will pop up it will ask "do you want to remove binary data"select "NO".
and allow box to reboot.

STEP 2:Now carry out the box upgrade via RS232 cable as per instructions..make sure it is ran through COM PORT 1 or it wont work..just follow the instructions in any one of the pages in the file there are 2 but both the same instructions..it will take about 2 seconds to download and complete..Then remove cables etc and boot box as normal.
then power off box and carry out a flash with genuine image as normal and BINGO box is as genuine.
 
Status
Not open for further replies.
Top