- Home
- Forums
- HDTV And Ultra HDTV
- Other HDTV Receivers
- Cuberevo - Ipbox 9000
- Cuberevo - Ipbox 9000 Chat
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Booting Problem on Cuberevo HD
- Thread starter ava
- Start date
First i had sifteam 11102 then flashed with ENIGMA2 SWF after that last version of ENIGMA1 and PGI ver0.02.
when PGI was booting,stoped on booting and i had to flash with dgs-9580(official release)and then reflashed sifteam11102 ,the problem solved but sometimes stop on booting again and i would be turn off it from rear panel.
when PGI was booting,stoped on booting and i had to flash with dgs-9580(official release)and then reflashed sifteam11102 ,the problem solved but sometimes stop on booting again and i would be turn off it from rear panel.
Last edited:
I have a init problem with my USB harddisk.
It sometimes takes 5s before the HD is ready to boot and Ipbox only waits 3s. Ipbox stops at Cuberevo> promt at service port.
Writing boot at the promt restarts the boot process and this normally works.
Could it be the same you are seeing? Are you using USB stick,USB Harddisk or eSATA Harddisk?
It sometimes takes 5s before the HD is ready to boot and Ipbox only waits 3s. Ipbox stops at Cuberevo> promt at service port.
Writing boot at the promt restarts the boot process and this normally works.
Could it be the same you are seeing? Are you using USB stick,USB Harddisk or eSATA Harddisk?