How to control a motorised dish?

astrodog66

Registered
Messages
996
Can anyone point towards a guide on how to get a 4+ Uno 4k to drive a motorised dish via disecq? The guides I have encountered so far are all for usals, but as I understand usals is not compatible with my equipment.

The system:

Vu+ 4k uno with black hole 3.04

Moteck V-Box II

Inverto quad ultra lnb

Channel master 1.25m dish

Jaeger 1224 h-h mount.


Can anyone confirm whether this setup is usals compatible, or whether I have to stick with disecq?

Also when moving from one satellite to another with the vu+, can you select it through the receiver's interface as you do with non enigma 2 boxes, or do you have use the moteck v-box?
 
Last edited:

Tesfer

Registered
Messages
78
You can't use USALS with a vBox, but when everything is set up you can control the vBox from your receiver.

I don't have a 4k box but I presume the enigma2 commands are the same as a non 4k box.

The easiest way to set up your set up is by using the Tuner menus
 

Rickk

Registered
Messages
2,375
v-box 2 can only diseqc 1.2 not usals
the receiver that works with the v-box seems to be a matter of luck
 
Top