I always recommend After you download the necessary files needed you unpack them and save them to Desktop this way you know where to find them
You will need both your Usb & serial cable plugged into your Cas Programmer, to successfully programme your Gamma Card using Besttt Loader v2.0.
1.Start up the CIS 8.6c software, you should have a shortcut icon on your desktop.
2.Click on the Utilities tab, and then PHOENIX icon,
3. Click on Phoenix @ 6.00Mhz
4. Click on Hide
5. Open Besttt Loader V2.0
6.Now insert your Gamma card chip facing down
7. Click on Load File
8. Navigate to your desktop to where you have saved 09_07_2009_cy_gr.bes
highlight it and click open.
9.Now click Programme Card
and wait for the Card to finish programming.
After it programmed successful click exit and remove your card
Regards Compass..