Hello there,this is my first post.
I installed a WD hard disk 2T in my genuine dm8000. After flashing image, via configure menu I formatted the hd. Then starting recording and playng movies was ok. The problem is when I reboot the system, becouse I can't access anymore to hdd. Via configure menu, if I check the hard disck, the task interrupts with FAILED Fsck message. If I repeat the fsck control logging in via telnet, I can see the HDD, I can mount it (device name /dev/hda1, mount point /media/HDD) , and finally start again recording and playing movie. Everything looks OK if I don't reboot. I controlled the fstab file in /etc, but line with auto mounting partition device is ok. Any advise?
Fabio
I installed a WD hard disk 2T in my genuine dm8000. After flashing image, via configure menu I formatted the hd. Then starting recording and playng movies was ok. The problem is when I reboot the system, becouse I can't access anymore to hdd. Via configure menu, if I check the hard disck, the task interrupts with FAILED Fsck message. If I repeat the fsck control logging in via telnet, I can see the HDD, I can mount it (device name /dev/hda1, mount point /media/HDD) , and finally start again recording and playing movie. Everything looks OK if I don't reboot. I controlled the fstab file in /etc, but line with auto mounting partition device is ok. Any advise?
Fabio