BDC ATR Restorer Script

Status
Not open for further replies.

007.4

VIP
Messages
364
I've made some major changes to my BDC_ATR_Restorer WinExplorer script.

This will NOT resurrect a card that has been killed with a killer BDC file.

However, it will restore the ATR to a BDC which is stuck in application mode and the Dragon Loader cannot erase or detect it.

You must use a Phoenix Interface, initially at 6.00 MHz, ideally in a "real" rs232 comport. Then, when prompted, change to 3.57 Mhz and run the script again. It works fine for me with a CAS3 interface.

Please give feedback on any success or not.

007.4
 

007.4

VIP
Messages
364
For CAS3 you need to connect both USB and serial leads. Then run CAS studio in utilities/Phoenix mode (6MHz) and hide.
The start Winexplorer (select correct comport) run the script.
The go back into CAS studio and change the setting to 3.579 MHz and run the script again
 
Status
Not open for further replies.
Top