How to install the BlackHole Prism image

elgeneral

Registered
Messages
7,811
1.Please download latest version of the BlackHole Prism image from this site and extract it from the zip file.
You will find the directory update_ruby

4x63.jpg


2. Now please format your USB stick to FAT32 and copy folder "update_ruby" to root of the usb stick

3z3n.jpg


3. Now plug the USB stick into the USB slot (found at the rear of your box).

4. Power on your Prismcube - after a while, it will automatically start to instal the software, and the display will show UPDATE

6ibp.jpg



Your display will show numbers and letters as it is updating block by block the flash on your box

563f.jpg


4 When complete, you will be asked to remove the usb stick - REMOVE USB

1r96.jpg


5. After removing the usb stick from the rear, the receiver will start booting

2s4c.jpg


It will take a couple of minutes to fully reload, and then you will have full access to the menu system.

Now please setup new receiver, or restore the previously saved.

Big thanks to bogdanm
 
Top