Opticum Sloth Combo HD

junebox

Registered
Messages
2
Kolego JAKITAKI czy soft Opticum Sloth Combo emu v2.1.02 dotyczy tego samego tunera albowiem OPTICUM do SLOTH COMBO podają ,że posiada procesor Sunplus 1506A i do niego niby pasuje soft Opticum Sloth Combo emu v 2.0.91 natomiast ten co podajesz z dnia 17.03.2016 czyli v 2.1.02 dotyczy procesora Sunplus 1512.Pytanie zasadnicze czy po załadowaniu tego softu nie rozkraczy się tuner.Gdyby nie, to czy soft U2C MASTER S2+T2 V2.1.16 /POSIADAJACY PROCESOR Sunplus 1512/ bedzie pasował do Opticuma.
 

JAKITAKI

Super VIP
Messages
9,214
Kolego JAKITAKI czy soft Opticum Sloth Combo emu v2.1.02 dotyczy tego samego tunera albowiem OPTICUM do SLOTH COMBO podają ,że posiada procesor Sunplus 1506A i do niego niby pasuje soft Opticum Sloth Combo emu v 2.0.91 natomiast ten co podajesz z dnia 17.03.2016 czyli v 2.1.02 dotyczy procesora Sunplus 1512.Pytanie zasadnicze czy po załadowaniu tego softu nie rozkraczy się tuner.Gdyby nie, to czy soft U2C MASTER S2+T2 V2.1.16 /POSIADAJACY PROCESOR Sunplus 1512/ bedzie pasował do Opticuma.

- po pierwsze
na forum obowiązuje język angielski
- po drugie
tak ten soft co podałem pasuje do Sloth Combo
z poziomu tunera jest obecnie do pobrania nowszy soft 2.1.24

softy z U2C Mastera nie podchodzą
 

HARUNBOY

Registered
Messages
5
I need for Opticum Sloth Combo Plus PVR {RS232} Loader

Opticum Sloth Combo Plus PVR Display is only ON
 

JAKITAKI

Super VIP
Messages
9,214
I need for Opticum Sloth Combo Plus PVR {RS232} Loader

Opticum Sloth Combo Plus PVR Display is only ON



1. Unpack the software you want to upload
2. Change the name to top_upgrade.bin
3. Copy it to the USB root directory
4. Turn off the tuner from the power supply
5. Insert the USB port into the tuner's USB port
6. Turn on the tuner to power, press OK (4x) on the tuner's front panel
times) until the update starts (Load)

if you can not do it, it's a UartAssist tool, by rs232
 

JAKITAKI

Super VIP
Messages
9,214
arka plan değiştirme programı varmı acaba


Serwer -> Settings -> IP Receiver

Snap1.png


connect with the receiver

Snap2.png


View -> Boot Picture

Snap5.png
 
Top