Issue with my TM-5200 USB Super serie??

mehdi3

Registered
Messages
155
Hi everyone

Actually im using a Technomate receiver TM-5200 super serie and I downloaded a wrong TM-softcam to receiver and now the receiver keep freezing and the picture go to black and white every an hour and I have to switch off the receiver and turn it on.
I did download a right TM-softcam after that but I still have same issue.

Is there anyone on here can help me with this issue??
 

jamsb

Registered
Messages
184
Back up your c/list.

Factory reset.

Load patch again ,factory reset again.

Load your saved channel list.

Load correct softcam for Tms.
 

mehdi3

Registered
Messages
155
I have done all this step one by one but its still the the same issue.

Is there anyone had this issue which I have now with my receiver?
 

mdt

VIP
Messages
905
try loading official technomate software for your reciever then use it for a while to see if its ok,regards mdt
 

mehdi3

Registered
Messages
155
I also downloaded the official S.W from Technomate site but its still the same.

I think some part has been damaged in the main board.
 

force1

Registered
Messages
40
A common problem is the power supply, usually only one capacitor needs changing, a very cheap repair.
 

mehdi3

Registered
Messages
155
I replaced the power supply and im still having that issue,im sure there is something wrong in the board as the receiver keep freezing and picture goes to black and white.
 
Top