The New Issue from FLYCCCAM v0.4

Status
Not open for further replies.

Salah Said

HUMAX fan
Messages
163
A new Version from FLYCCCAM v0.4 has been issued dated 17/10/2009

and here is the announcement from the site

00site.jpg


It is mainly as previous versions with little changes


Sharing CCCam is mainly one line server or many lines servers
We put this (These) server(s) in a file called flyccam.cfg
using the NotePad of windows

07cfg.jpg


After putting the server(s)
We start the program from a file called SSSP Plug.exe
and it is located in the main folder

01mains.jpg


then comes the advertisement scrren
and we close it

02message.jpg


the the Monitor appears

03monitor.jpg


Then we start the program and press CONNECT
the program will start and get the code

04mainworking.jpg


and we notice the Monitor and the code it brought

05monitorwork.jpg


And in case the Monitor did not appear
You can show it yourself

06getmonitor.jpg


It has to be noted that
the preparation in the Config page of the Humax 5400 is
Card+S+Emu
Ecm+Emm
SSSP

And you can use any software (Firmware) as you like
Starting from 7.5 till 11.1

I hope you keep Enjoying Humax 5400
Best regards and wishes

the program is Attached

 

baloota

Registered
Messages
2,055
A new Version from FLYCCCAM v0.4 has been issued dated 17/10/2009

and here is the announcement from the site

00site.jpg


It is mainly as previous versions with little changes


Sharing CCCam is mainly one line server or many lines servers
We put this (These) server(s) in a file called flyccam.cfg
using the NotePad of windows

07cfg.jpg


After putting the server(s)
We start the program from a file called SSSP Plug.exe
and it is located in the main folder

01mains.jpg


then comes the advertisement scrren
and we close it

02message.jpg


the the Monitor appears

03monitor.jpg


Then we start the program and press CONNECT
the program will start and get the code

04mainworking.jpg


and we notice the Monitor and the code it brought

05monitorwork.jpg


And in case the Monitor did not appear
You can show it yourself

06getmonitor.jpg


It has to be noted that
the preparation in the Config page of the Humax 5400 is
Card+S+Emu
Ecm+Emm
SSSP

And you can use any software (Firmware) as you like
Starting from 7.5 till 11.1

I hope you keep Enjoying Humax 5400
Best regards and wishes

the program is Attached


patch FLYCCCAM
 
Status
Not open for further replies.
Top